September/2022 Latest Braindump2go 350-501 Exam Dumps with PDF and VCE Free Updated Today! Following are some new Braindump2go 350-501 Real Exam Questions!

QUESTION 330
Refer to the exhibit. An engineer at ISP C is configuring a new interconnection with ISPs A and B using the BGP protocol. After the initial configuration, the engineer noticed high memory usage and an abnormally large LIB table on router R2. Which two actions must the engineer take on R2 to minimize memory usage? (Choose two.)

A. Configure the mpls ldp neighbor 11.11.11.11 labels accept 1 command.
B. Configure Standard ACL 1 with accepted prefixes.
C. Configure Extended ACL 101 with accepted prefixes.
D. Configure the mpls ldp neighbor 1.1.1.1 labels accept 101 command.
E. Configure the mpls ldp neighbor 21.21.21.21 labels accept 101 command.

Answer: AB

Read more

August/2022 Latest Braindump2go 300-715 Exam Dumps with PDF and VCE Free Uodated Today! Following are some new Braindump2go 300-715 Real Exam Questions!

QUESTION 210
An engineer is configuring the remote access VPN to use Cisco ISE for AAA and needs to conduct posture checks on the connecting endpoints. After the endpoint connects, it receives its initial authorization result and continues onto the compliance scan.
What must be done for this AAA configuration to allow compliant access to the network?

A. Configure the posture authorization so it defaults to unknown status
B. Fix the CoA port number
C. Ensure that authorization only mode is not enabled
D. Enable dynamic authorization within the AAA server group

Answer: D

Read more

July/2022 Latest Braindump2go 300-810 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 300-810 Real Exam Questions!

QUESTION 183
An engineer must verify that the DNS SRV entries that are configured have the correct information.
How is this configuration completed via a Windows machine?

A. Go to Windows Explorer and type nslookup. Set the type=internet, and then enter the SRV record.
B. Go to the command prompt and type dnslookup. Set the type=sip. and then enter the SRV record.
C. Go to Internet Explorer and type nslookup. Set the type=srv, and then enter the SRV record.
D. Go to the command prompt and type nslookup. Set the type=srv, and then enter the SRV record.

Answer: D

Read more

July/2022 Latest Braindump2go 400-007 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 400-007 Real Exam Questions!

QUESTION 54
You were tasked to enhance the security of a network with these characteristics:
– A pool of servers is accessed by numerous data centers and remote sites
– The servers are accessed via a cluster of firewalls
– The firewalls are configured properly and are not dropping traffic
– The firewalls occasionally cause asymmetric routing of traffic within the server data center.
Which technology should you recommend to enhance security by limiting traffic that could originate from a hacker compromising a workstation and redirecting flows at the servers?

A. Poison certain subnets by adding static routes to Null0 on the core switches connected to the pool of servers.
B. Deploy uRPF strict mode.
C. Limit sources of traffic that exit the server-facing interface of the firewall cluster with ACLs.
D. Deploy uRPF loose mode

Answer: C

Read more

June/2022 Latest Braindump2go 300-410 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 300-410 Real Exam Questions!

QUESTION 351
Refer to the exhibit. TCP traffic should be reaching host 10.10.10.10/24 via R2.
Which action resolves the issue?

A. TCP traffic will reach the destination via R2 without any changes
B. Add a permit 20 statement in the route map to allow TCP traffic
C. Allow TCP in the access list with no changes to the route map
D. Set IP next-hop to 10.10.12.2 under the route-map permit 10 to allow TCP traffic.

Answer: C

Read more

June/2022 Latest Braindump2go 300-710 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 300-710 Real Exam Questions!

QUESTION 212
An administrator Is setting up a Cisco PMC and must provide expert mode access for a security engineer. The engineer Is permitted to use only a secured out-of-band network workstation with a static IP address to access the Cisco FMC. What must be configured to enable this access?

A. Enable SSH and define an access list.
B. Enable HTTP and define an access list.
C. Enable SCP under the Access List section.
D. Enable HTTPS and SNMP under the Access List section.

Answer: A

Read more

June/2022 Latest Braindump2go 200-301 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 200-301 Real Exam Questions!

QUESTION 668
Refer to the exhibit. Which change to the configuration on Switch2 allows the two switches to establish an EtherChannel?

A. Change the protocol to EtherChannel mode on.
B. Change the LACP mode to active
C. Change the LACP mode to desirable
D. Change the protocol to PAqP and use auto mode

Answer: B

Read more

June/2022 Latest Braindump2go 350-401 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 350-401 Real Exam Questions!

QUESTION 794
What is the recommended minimum SNR for Voice applications for networks?

A. 15
B. 20
C. 25
D. 10

Answer: C

Read more

May/2022 Latest Braindump2go 200-201 Exam Dumps with PDF amnd VCE Free Updated Today! Following are some new 200-201 Real Exam Questions!

QUESTION 260
A user received a targeted spear-phishing email and identified it as suspicious before opening the content. To which category of the Cyber Kill Chain model does to this type of event belong?

A. weaponization
B. delivery
C. exploitation
D. reconnaissance

Answer: B

Read more

June/2022 Latest Braindump2go 350-801 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 350-801 Real Exam Questions!

QUESTION 317
Which configuration concept allows for high-availability on IM and Presence services in a UC environment?

A. IM and Presence subclusters (configured on Cisco UCM)
B. Presence Redundancy Groups (configured on Cisco Unified IM and Presence)
C. IM and Presence subclusters (configured on Cisco Unified IM and Presence)
D. Presence Redundancy Groups (configured on Cisco UCM)

Answer: D

Read more